Registering for Access

If you do not have a G-EGD account, you need to register for access before you can log in. This may be because you do not have login credentials yet, or because your CAC credentials require approval before you are granted access (see Logging In with a Common Access Card (CAC)).

  1. Open an Internet browser and go to: https://evwhs.digitalglobe.com. The Log In screen opens.

  2. Do one of the following, depending on your account type:

    • CAC Users Insert your CAC into your CAC reader, then select CAC Access. At the prompt, enter your PIN.

    • Non-CAC Users Select Get Registered.

    The registration page opens.

  3. Complete the required fields, then select Submit My Request. A verification code dialog opens.

    Verification Code Dialog

  4. You will receive an email containing a verification code at the email address you provided on the registration page.

    The code expires within the time indicated in the verification code dialog and in the email. If you do not receive an email, check your spam folder.

  5. In the confirmation dialog, enter the verification code, then select Submit.

    Do not close your browser. Your browser must remain open to enter the verification code. If you close your confirmation dialog, please contact Maxar technical support.

    If your code expires while the dialog is open, or if you did not receive the email, select Resend in the confirmation dialog to resend the verification code.

  6. To complete your request, follow the prompts.

    Required Information Dialog

    If you meet the conditions of auto-approval, you can immediately log in to G-EGD. Otherwise, you will receive a confirmation email after you are approved.